JBL WIND3 FM Bluetooth Handlebar Speaker User Guide



JBL WIND3 FM Bluetooth Handlebar Speaker


Bicycle MountJBL-WIND3-FM-Bluetooth-Handlebar-Speaker-FIG-1

  1. included the Install onto bracket mounting .handlebars bicycle
  2. Dock the undock/ them into speaker bracket mounting effortlessly

WHAT’S IN THE BOXJBL-WIND3-FM-Bluetooth-Handlebar-Speaker-FIG-2JBL-WIND3-FM-Bluetooth-Handlebar-Speaker-FIG-3


  • long press to switch EQ between ‘Sport’ and ‘Bass’ mode

Bluetooth pairingJBL-WIND3-FM-Bluetooth-Handlebar-Speaker-FIG-5

FM RADIOJBL-WIND3-FM-Bluetooth-Handlebar-Speaker-FIG-6

  1. Source Switch to FM mode

Press 1x to tune down/up by step manually Press 2x to tune to the previous/next preset station
Long press to search for and tune to the previous/next available station automatically

TF / AUX-INJBL-WIND3-FM-Bluetooth-Handlebar-Speaker-FIG-7




  • Transducer: 43 mm 47 mm/1.5″
  • Output power: 5W RMS
  • Frequency response: 110 Hz-20 kHz
  • Signal-to-noise ratio: 85 dB
  • Battery capacity: 1050 mAh
  • Battery charge time: 2.5 hours (5V=1A)
  • Music play time: up to 5 hours (dependent on volume level and audio content)
  • Bluetooth version: 5.0
  • Bluetooth profile: A2DP 1.3, AVRCP 1.6, HFP 1.7
  • Bluetooth transmitter frequency range: 2400 MHz-2483.5 MHz
  • Bluetooth transmitter power: <5 dBm (EIRP)
  • Bluetooth transmitter modulation: GFSK, T/4 OPSK, 80PSK
  • FM Tuning range: 87.5 MHz-108 MHz (varies by country)
  • Dimensions (Wx HxD): 90 mm x 73.2 mm x 35.8 mm
  • Weight: 0.230 kg
  • Maximum operation temperature: 45°C


To protect battery lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions. Do not expose the JBL Wind 3 to liquids without removing the cable connection. Do not expose JBL Wind 3 to water while charging. It may result in permanent damage to the speaker or power source. Chemicals, salt, or “foreign particles” in your pool or the ocean can damage the waterproof seals or harm the connector surface over time if not rinsed off after use. After a liquid spill or rinse, do not charge your speaker until it’s completely dry and clean. Charging when wet might damage your speaker. When using an external adapter, the output voltage/ current of the external adapter should not exceed 5V/3A.JBL-WIND3-FM-Bluetooth-Handlebar-Speaker-FIG-10

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.


Documents / Resources

JBL WIND3 FM Bluetooth Handlebar Speaker [pdf] User Guide
JBLWIND3, APIJBLWIND3, WIND3 FM Bluetooth Handlebar Speaker, FM Bluetooth Handlebar Speaker, Speaker

Leave a Comment